1" dimplex x 1/4" hole, 2pc. Single shields are used for new installation where the cable or wire may pass through the hole. Flat shields for use in thick firewalls. Ream pilot hole in single piece shields oversize for the size grommet used. Two piece shields are perfect for adding grommet protection to use over cables or wires with large end-fittings or existing installations. Actual hole size in 2 piece shields is slightly larger than indicated to prevent chafing cable. Dimple shields accommodate rubber grommets up to 7/8" O.D. Shields may be installed with screws, bolts, plate nuts or rivnuts. Install cable and grommet in firewall, center shield on cable, drill attach holes. Shields have 5/32" mounting holes. Note: If more than one cable passes through grommet fire resistant sealant must be applied to grommet. Seals are designed to protect sealing material from excessive heat-not carbon monoxide in cockpit. Preserving the life of the grommet or sealing material is critical to preventing smoke, carbon monoxide or fumes from entering the cockpit. Use extreme caution when installing.
Code 8
# Per Ship |
N/A |
Special Order |
N/A |
Call For Pricing |
N/A |